秒速时时彩官网

联系我们

联系人: 刘经理 手机: 15953131568        18888346536 QQ: 408031499 网址:  地址: 济南市天桥区金牛建材市场

新闻中心当前位置:首页—新闻中心

防火卷帘门验收规范
2018-9-5 15:05:53
1、防火卷帘门应满足的技术要求
1. Technical requirements for fire shutter doors.
3.1平均升降速度:3米/分钟。
3.1 average lift speed: 3 M / min.
3.2耐火时间:240分钟。
3.2 fireproof time: 240 minutes.
3.3漏烟量:0.18M?/分钟。
3.3 leakage amount: 0.18M? / min.
3.4电动上下,自动闭锁,手动开启。
3.4 electric up and down, automatic locking, manual opening.
3.5接到烟温感信号,卷帘自动迫降。
3.5 receives the smoke temperature sense signal, the rolling curtain automatic landing.
3.6接到消防控制中心信号,可迫降到底或停在任意位置。
3.6 receiving the signal from the fire control center, it can be forced to drop or stop at any location.
2、外观要求
2. Appearance requirements
2.1帘板、导轨、门楣、卷轴等部位的表面不允许有裂纹、压坑及较明显的凹凸、锤痕、毛刺、空洞等缺陷。

2.1 The surface of curtain board, guide rail, lintel, scroll and other parts is not allowed to have cracks, pits and more obvious concave and convex, hammer marks, burrs, cavities and other defects.

济南卷帘门厂

2.2相对运动在切割、弯曲、冲钻等加工处,必须清理毛刺。
2.2 relative motion must be cleaned up in cutting, bending and drilling.
2.3构件或零部件的组装、拼接处不允许有错位。
2.3 the assembly and splicing of components or components are not allowed to be misplaced.
2.4焊接处应牢固,外观平整、不允许有夹渣、漏焊等现象。
2.4 the welding point should be firm, the appearance is smooth, and no slag inclusion and leakage welding are allowed.
2.5零部件的外漏表面,必须做防锈处理,其涂层、镀层应均匀,不得有斑剥的现象。
2.5 Leakage surface of parts and components must be rust-proof treatment, its coating, coating should be uniform, no spalling phenomenon.
2.6所有紧固件必须紧牢,不允许有松动现象。
2.6 all fasteners must be fastened and no loosening is allowed.
3、帘板主要质量要求
3. Main quality requirements of curtain panels
3.1相邻互锁帘板串接后转动灵活,摆动±90°不允许脱落,对具有防烟性能的重叠形帘板串接后,摆动±90°不允许脱落。
3.
3.2帘板两端挡板或防窜机构装配要牢固,装配成卷帘后,帘板窜动量不得大于2mm。
3.2 The baffles at both ends of the curtain board or the anti-channeling mechanism should be firmly assembled. When the curtain is assembled into a roll, the channeling amount of the curtain board shall not exceed 2 mm.
3.3帘板要平直,帘板直线度每米不得大于3.5mm,全长直线度不得超过0.12%。
3.3 curtain plate should be straight. The straightness of curtain should not exceed 3.5mm, and the length straightness should not exceed 0.12%.
3.4帘板装配成卷帘后,不允许有空洞和缝隙存在。
3.4 when curtain panels are assembled into rolling shutters, no holes and gaps are allowed.
3.5具有防烟性能的帘板,内外鼻钩窜接后的接触面成弧面接触,弧度角在30°范围内必须接触。
3.5 The curtain board with smoke-proof property has a Globoidal contact with the contact surface after the internal and external nose hooks are channeled. The curvature angle must be contacted within 30 degrees.
3.6帘板装配成卷帘后,在运行时不允许有倾斜,应当平行升降,卷帘的不平直长不大于洞口高度的1/300。
3.6 After the curtain is assembled into a roll, no inclination is allowed during operation, and the curtain should be raised and lowered in parallel. The uneven length of the roll is not more than 1/300 of the height of the orifice.
友情链接:云顶彩票  金彩彩票  环球彩票平台  鸿利彩票登陆  大发彩票投注  金彩彩票  盛兴彩票网站  

免责声明: 本站资料及图片来源互联网文章,本网不承担任何由内容信息所引起的争议和法律责任。所有作品版权归原创作者所有,与本站立场无关,如用户分享不慎侵犯了您的权益,请联系我们告知,我们将做删除处理!